Land Rover Lightweight Hard Top – RAF Olive Green 1/76
Add to compare5 in stock
£8.99
5 in stock
Oxford 1/76 scale LRL005: Land Rover Lightweight Hard Top in RAF olive green with yellow stripe. These models are very compatible with 1/72 scale diecast aircraft models.
Length 1.75 inches Width 0.5 inches
In the early 1960s both the Royal Marines, then largely based aboard commando carriers, and the British Army required a vehicle that could be carried by air to replace the Austin Champ. They had taken delivery of the Westland Wessex helicopter, which could carry a 2,500 lb (1,134 kg) load slung beneath.
The smallest Land Rover available at the time was a Series IIA 88 inch (2235 mm) wheelbase, which was too heavy. Land Rover began work on a lightweight version to fit the specifications in 1965. A new modification to the basic Series IIA was devised by making many body components easily detachable and removing many non-essential items. The result was the Land Rover Half-Ton, known widely as the Lightweight or Airportable. In practice, to reduce weight sufficiently for the helicopters of the day to lift them in combat conditions, the tilt (roof) and sticks, the upper parts of the body, the doors and windscreen were removed, to be refitted later. The most significant change, however, was a reduction in width by 4 inch (100 mm), by redesigning the standard Series IIA axles and fitting shorter half-shafts, which meant it would fit on a standard pallet.
Complete, the Lightweight IIA weighed 2,650 lb (1,202 kg), over the specified weight. The term Lightweight appears misleading as a standard 88 Land Rover weighed 1,318 kg (2,906 lb), but the higher total weight was due to the various frame reinforcement required for military usage. However, with the removable body panels taken-off it was below the limit. Since improvements to the helicopters meant more lift was available, the MoD accepted it for use. The main applications were actually to be shipped by cargo aircraft or stacked on train wagons, with helicopter transport a rare occurrence.
The first production models were completed on 11 November 1968, and production continued until 1984.
Production
Although a very few prototypes had been built between 1965 and 1967, and about six pre-production models early in 1968, ‘Lightweight’ Series IIA quantity production began on 11 November 1968, with a total of 15 vehicles being produced on that day. Total production of Series IIa ‘Lightweights’ was between 1,500 and 2,000 vehicles. Later Series IIa models had the headlamps moved out into a revised front wing, to comply with revised lighting regulations. It is easy to confuse later Series IIa models with the Series III, though nothing was changed on these vehicles other than the location of the headlamps.
The Series IIA Lightweight was replaced by the Series III Lightweight in 1972, soon after the replacement of the civilian Series IIA with the Series III. The vehicle remained in essence the same, with a few relatively minor changes – there are detail differences to the chassis; and a revised gearbox had synchromesh on second through fourth gears instead of just third and fourth. In the electrical department the Series III was fitted with an alternator in place of the dynamo of the Series IIa; the new indicator switch incorporates a headlamp flasher and horn; and the ignition switch was now fitted in a new steering column cowl instead of on the dashboard. The Lightweight did retain the earlier Series IIa metal dashboard even after the upgrade. Around 1980, in line with civilian models, the engine had five main bearings instead of three.
Lightweight production ended in 1984, when the parent Land Rover Series III was replaced by the models 90 and 110. A total of 37,897 Lightweights, petrols and diesels, were built.
Weight | 0.5 kg |
---|